CSR (SirF) change the binary protocol whne they introduced the Sirf IV gps modules. The protocols are very similar but OSP has additional features. Is you are using the ISM300x family of GPS modules use the Sirf Binary. If you … Continue reading “What is the difference between the Sirf Binary and the OSP One Socket Protocol?”

Yes, the ISM300Fx can be flashed in system by pulling pin 8 High upon power up. The module will then boot up in flash mode and you can update the firmware over the UART. This pin has a pulldown interanlly … Continue reading “Can I flash my ISM300Fx GPS in system?”

The GPS modules do not come marked with the Firmware version. You can poll the software using Sirf Binary for the ISM300fx modules and use OSP (one Socket Protocol) for the ISM4xx version of gps modules. If you want to run … Continue reading “How do I confirm my firmware revision on the GPS module?”

The RF in port on the ISM300 connects to the antenna (via the U.fl) or pad 1 and the input of the GPS. It is important to add the external LC circuit shown in the reference schematic on the specification because this will … Continue reading “On the ISM300Fx how should I connect my antenna?”

Use the ISM300f2-x family of GPS’s.

Ideally, if you can connect your PC to the UART for any of the ISM300x or ISM400x GPS modules you can run the Sirf Live. Sirf Live will show you all the satellites and C/no and allow you to send commands and … Continue reading “What application do you have to help troubleshoot the GPS design?”

Yes, all our modules are ROHS compliant.

The FCC does not require that the GPS receiver has FCC or CE. We did perform FCC on the Sirf III for a specific customer request, however it is not required.

Yes, if you use the battery back up feature and keep power alive the unit will store the data and provide warm starts. The ISM400x GPS do not require the battery back up.

No, we do not support sub-meter accuracy.