Cypress WICED™

Inventek Systems offers a family of serial-to-WiFi modules (eS-WiFi™ family) that support Cypress WICED™ platform. The option is available to use either Inventek’s AT Command Set firmware or Cypress WICED APIs.  When using Inventek’s AT Command Set, a low cost system microcomputer is used to send commands to the eS-WiFi module over a serial interface (UART, SPI or USB).  When using Cypress WICED platform, the on-board microcomputer is used for both the WICED firmware and system program. In either case, the module hardware is identical and consists of a Cypress BCM43XX single chip wireless radio, embedded Cortex M3 Microcomputer and integrated antenna (or U.FL option) all on a 14.5mm x 34mm module with 44 LGA footprint or USB dongle.

WICED™ – Wireless Internet Connectivity for Embedded Devices (Cypress)

Cypress Wireless Internet Connectivity for Embedded Devices (WICED) platform eases the development effort and simplifies the implementation of Wi-Fi connectivity in an array of consumer devices, especially those with no current networking support.

WICED modules enable the addition of secure, interoperable Wi-Fi functionality via a simple serial port using a basic command set that does not require any significant changes in product micro-controller architectures.

eS-WiFi™ – Embedded Serial-to-WiFi Modules (Inventek Systems)

Inventek’s eS-WiFi modules build upon the WICED platform by adding another step in integration and ease of design-in.  These AT Commands allow the use of simple instructions to establish connectivity and configure the module as a client or Access Point.  Over 100 commands are now available and include a broad list of basic and advanced commands (Find, Scan, Join, Send, Receive, Run SoftAP, Direct Connect Mode, SSL Mode, etc.).

*Cypress WICED Registration Required

Cypress WICED SDK Patches by release (zip)

United States Inventek Systems $$ 2013-02-07T13:55:09-05:00 2019-06-10T11:21:42-04:00