Modules are not officially certified as WiFi Direct, however our modules accomplish Wi-Fi Direct using a “Direct Connect” mode. In the Direct Connect mode, the SoftAP is running on the module and you establish a direct infrastructure mode connection with the … Continue reading “Do you support Wi-Fi Direct?”

Drivers are NOT required to use eS-WiFi modules. AT commands are sent over the serial interface (UART, SPI or USB).

Inventek is in development of a 5 GHz dual band solution that will fit in the exact same L44 footprint. The antenna portion of the design will need to be extended.  We are expecting to release the 5 GHz in 2013.

Yes, we support 802.11 b/g/n.

Yes, all the currently available eS-WiFi modules are footprint compatible. (44 pin LGA)

There are two ways to rest the module. 1.) To do a Soft reset type the AT command  <ZR> Or 2.) Pull the module Reset pin low

1. Set Protocol to UDP 2. Set Local port number 3. Start UDP Comm Server EX. P1=1    Select UDP Protocol P2=5024    Set Port 5024 P5=1    Start UDP Comm Server

No, the module uses 3.3 volt logic.

Yes, all of the above.

You can use AT Commands over the UART, SPI or USB HID interface to send commands and send/receive data.